Owners Manual

Next steps
Replace the control panel module.
Installing the control panel module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Insert the control panel module behind the notch on the chassis.
2. Align the screw holes on the control panel module with the screw holes on the chassis.
3. Using the Phillips #1 screwdriver secure the panel to the to the chassis with the screws.
4. Connect the control panel cable to the control panel connector.
Figure 105. Installing the control panel module
Next steps
1. Install the system top cover (front).
2. Follow the procedure listed in After working inside your system on page 24.
100
PowerEdge C4140 installing and removing system components