Owners Manual

Figure 36. Removing a 2.5-inch cabled drive from the drive cage

Next steps

1. Install the drives.

2. Install the drive cage cover.

3. Install the drive cage into the drive cage slot in the chassis.

Installing a 2.5-inch cabled drive into the drive cage

Prerequisites

NOTE:

To identify the drive, see the label on the drive cable. For more information, see Drive Specifications in the

PowerEdge C4140 Technical Specs at .www.dell.com/poweredgemanuals.

1. Follow the safety guidelines listed in the Safety instructions section.

2. Keep the Phillips #2 screwdriver ready.

3. Remove the 2.5-inch drive cage.

4. Remove the 2.5-inch drive cage cover.

Steps

To install drive 0 and drive 1, perform the following steps:

a. Slide drive 1 into the drive cage.

b. Lower drive 0 into the drive cage.

c. Secure the drives to the drive cage by using the screws.

NOTE:

If the 2.5-inch drive has Torx screw, use Torx 6 screwdriver to secure the drives to the drive cage.

Connect the power and signal cable to the drives.

NOTE: Ensure that the connector labeled HDD0 is plugged into upper drive before reinstalling bay.

38 PowerEdge C4140 installing and removing system components