Owners Manual

Installing an expansion card riser

Prerequisites

1. Follow the safety guidelines listed in Safety instructions on page 23.

2. if applicable, install an expansion card into the riser before installing the expansion card riser 2.

Steps

1. Holding the blue touch points on the expansion card riser, align the expansion card with the connector on the system board.

NOTE: While installing riser 1, press the tabs and hold the touch point to align the expansion card riser and the riser

guide pin on the system board.

2. Lower the expansion card riser into place until the expansion card riser is fully seated with the connector on the system

board.

Figure 45. Installing expansion card riser 1

PowerEdge C4140 installing and removing system components