Owners Manual

Figure 46. Installing expansion card riser 2

Next steps

1. Follow the procedure listed in After working inside your system on page 24.

2. Install any device drivers required for the card as described in the documentation for the card.

Removing an expansion card from the expansion card riser

Prerequisites

1. Follow the safety guidelines listed in Safety instructions on page 23.

2. Follow the procedure listed in Before working inside your system on page 24.

3. If applicable, disconnect the cables from the expansion card.

NOTE:

When removing a card from the riser 1, open the PCIe card holder latch. If applicable, remove the PCIe guide and

then remove the expansion card.

Steps

1. If applicable, lift the expansion card latches out of the slot.

2. Holding the expansion card by its edges, remove the card from the riser.

PowerEdge C4140 installing and removing system components