Owners Manual

Figure 60. Removing the network daughter card

Next steps

Replace the network daughter card.

Installing the network daughter card

Prerequisites

Follow the safety guidelines listed in Safety instructions on page 23.

Steps

1. Orient the NDC so that the Ethernet connectors fit through the slot in the chassis.

2. Align the captive screws at the back-end of the card with the screw holes on the system board.

3. Press the touch points on the card until the card connector is firmly seated on the system board connector.

4. Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the system board.

PowerEdge C4140 installing and removing system components