Owners Manual

Figure 61. Installing the network daughter card

Next steps

Follow the procedure listed in After working inside your system on page 24.

System battery

Replacing the system battery

Prerequisites

WARNING:

There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only

with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the

manufacturer's instructions. See the safety instructions that came with your system for more information.

1. Follow the safety guidelines listed in Safety instructions on page 23.

2. Follow the procedure listed in Before working inside your system on page 24.

3. Remove the expansion card riser 1.

Steps

1. Locate the battery socket. For more information, see the System board jumpers and connectors section.

CAUTION:

To avoid damage to the battery connector, you must firmly support the connector while installing

or removing a battery.

2. Use a plastic scribe to pry out the system battery.

PowerEdge C4140 installing and removing system components