Owners Manual

Figure 69. Removing the GPU I/O brackets and the support brackets
1. Torx screw (2) 2. support bracket
3. GPU 4. I/O bracket
5. screw (5)
Removing the GPU switch board
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 23.
2. Follow the procedure listed in Before working inside your system on page 24.
3. Remove the system top cover (front and rear).
4. Disconnect the GPU signal cables from the system board and then from the switch board.
NOTE:
The GPU riser signal cable should be removed from the switch board before removing the GPUs to prevent pin
damage in the GPU connectors on the switch board.
5. Remove all GPUs from the chassis.
6. Disconnect the switch board power cable.
7. Keep the Philips #2 screwdriver ready.
Steps
1. Loosen the screws securing the GPU switch board to the chassis.
2. Slide the GPU switch board toward the front of the chassis to disengage the slots on the GPU switch board from the tabs
on the chassis.
3. Lift the GPU switch board out of the chassis.
PowerEdge C4140 installing and removing system components
69