Owners Manual

Figure 73. Installing the GPU I/O brackets and the support brackets

1. Torx screw (2) 2. support bracket

3. GPU 4. I/O bracket

5. screw (5)

Next steps

Follow the procedure listed in After working inside your system on page 24.

Installing a GPU riser cable board

Prerequisites

1. Follow the safety guidelines listed in Safety instructions on page 23.

2. Keep the Philips #2 screwdriver ready.

3. Install the custom GPU brackets on the replacement GPU.

Steps

1. Route the riser cable through the riser cable clip.

2. Align the connector on the riser cable board with the card edge connector on the GPU and press till it clicks into place.

3. Align the screw holes on the riser cable board with the screw holes on the GPU bracket.

4. Secure the riser cable board to the GPU by using the screws.

PowerEdge C4140 installing and removing system components