Owners Manual

Figure 74. Installing a GPU riser cable from the system board

NOTE: The procedure to install the riser cable clip is same for configuration B, C and G.

NOTE: Do not hold the GPU by the GPU riser cable board.

Next steps

1. Connect the power cables to the GPU.

Installing a GPU

Prerequisites

1. Follow the safety guidelines listed in Safety instructions on page 23.

2. Follow the GPU installation guidelines listed in GPU installation guidelines on page 64.

3. Install the GPU brackets.

4. Install the GPU riser cable board.

Steps

1. Lower the front of the GPU at an angle and slide it to engage the slots on the GPU with the guide pins on the front inner

wall of the chassis.

NOTE: Do not hold the GPU by the GPU riser cable board.

CAUTION: While installing the GPU, ensure that the guide pins on the chassis do not scrape the GPU.

2. Lower the back of the GPU to engage the guide holes on the GPU with the guide pins on the chassis.

3. Connect the GPU power cables to the GPU and the system board or the switch board.

PowerEdge C4140 installing and removing system components