Owners Manual

Figure 85. Removing the SXM2-GPU heat sink
Next steps
Remove a SXM2 GPU
Removing the SXM2 GPU
Prerequisites
CAUTION:
To avoid any damage to the SXM2 GPU, ensure that you loosen the screws in a descending order
starting from the screw numbered 8, on the NVLink board.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in Before working inside your system.
3. Remove the NVLink air shroud.
4. Remove the SXM2-GPU heat sink.
Steps
1. Loosen the captive screws that secure the SXM2 GPU to the NVLink board in a descending order, as labeled on the NVLink
board.
2. Lift and remove the SXM2 GPU out of its socket on the NVLink board.
82
PowerEdge C4140 installing and removing system components