Hardware Owner's Manual

Using the System Setup Program 37
*2: [115200 8,n,1][57600 8,n,1][38400 8,n,1][19200 8,n,1][9600 8,n,1]
*3: [None] [Hardware] [Software]
*4: [ANSI] [VT100] [VT-UTF8]
*5: [Disabled] [Always]
Remote Access: [Disabled][Enabled] Select Remote Access type.
Serial port number: [COM1][COM2] Select Serial Port for console
redirection.
Current SOL Baud Rate: Information only. Displays the current SOL Baud
Rate.
Serial Port Mode: [115200 8,n,1][57600 8,n,1][38400 8,n,1][19200
8,n,1][9600 8,n,1]Select Serial Port settings.The default value may change if
SOL baud rate is fixed by customer request.
Base Address, IRQ: Information only. Displays the resource of the selected
COM.
Flow Control: [None][Hardware][Software]Select Flow Control for console
redirection.
Redirection After BIOS POST: [Disabled][Enabled]Disabled: Turns off the
redirection after POST. Enabled: Redirection is always active. (Some OSs may
not work if set to Always)
Termi nal Type: [ANSI][VT100][VT-UTF8] Select the target terminal type.
VT-UTF8 Combo Key Support: [Disabled][Enabled]: Enable VT-UTF8
Combination Key Support for AN-SI/VT100 terminals