Hardware Owner's Manual

58 Installing System Components
Removing 3.5" Hard-Drives
1 Remove the sled from the system. See "Removing a Sled" on page 50.
2 Remove the hard-drive screws from underneath the sled. See Figure 3-9.
Figure 3-9. Removing and Installing the 3.5" Hard-Drive Screws
3 Remove the hard-drive cables from the cable clips. See Figure 3-10.
4 Disconnect the hard-drive cables from the hard-drive board and system
board then lift the hard-drive out of the sled. See Figure 3-10.
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
Top of sled
Bottom of sled