Hardware Owner's Manual

80 Installing System Components
8 Secure the power cables and PMBus cables with the two cable clips on the
chassis. See Figure 3-27.
9 Secure the LAN cable and sideband cable with three cable clips. See
Figure 3-27.
10 Replace the backplane. See "Installing a Backplane" on page 77.
Removing the RTC Battery
1 Remove the sled from the system. See "Removing a Sled" on page 50.
2 Disconnect the RTC battery cable from the system board. See Figure 3-29.
3 Remove the RTC battery from the system board. See Figure 3-29.
Figure 3-29. Removing and Installing the RTC Battery
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 RTC battery connector 2 RTC battery
1
2