Owners Manual

1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in the Before working inside your system section.
4. Remove the cooling shroud.
1. Loosen the two retention screws on the PERC H730P slim-card cable connector.
2. Holding the pull tag, lift the PERC H730P slim-card cable connector from the system board connector.
3. Press the release latch on the side of the chassis to the unlock position and slide the PERC H730P slim card toward the back
of the system.
CAUTION: To prevent damage to the PERC H730P slim card, you must hold the card only by its edges.
4. Lift the card up and away from the system.
Figure 54. Removing a PERC H730P slim card
1.
standoff (2) 2. PERC H730P slim-card cable connector
3. pull tag 4. PERC H730P slim card
5. PERC H730P release latch 6. lock and unlock icon on the PERC H730P slim card bracket
Related references
Safety instructions on page 51
Related tasks
Before working inside your system on page 51
Removing the cooling shroud on page 56
102
Installing and removing sled components