Owners Manual

Installing a PERC H730P slim card
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
1. If installed, remove the PERC H730P slim card blank.
2. Press the release latch on the side of the chassis to the unlock position.
NOTE: Ensure that all the memory module ejectors are in the closed position.
3. Align the slots on the PERC H730P slim card with the standoffs on the side of the chassis.
4. Lower the PERC H730P slim card into the chassis until the slots on the card engage with the standoffs on the side of the
chassis.
5. Press the release latch to the lock position to secure the card firmly on the chassis.
The PERC H730P slim card connects to the backplane connector.
6. Hold the pull tag on the PERC H730 slim-card cable connector and route the cable between the memory-module ejectors.
7. Align the retention screws on the PERC H730P slim-card cable connector with the screw holes on the system board
connector.
8. Tighten the two retention screws to secure the PERC H730P slim-card cable connector on the system board.
Figure 55. Installing a PERC H730P slim card
a. PERC H730P slim card
b. PERC H730P release latch
c. lock and unlock icon on the PERC H730P slim card bracket
Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 51
Installing and removing sled components
103