Owners Manual

b. Memory modules
c. Cooling shroud
d. Hard drive or SSDs
e. Hard drive or SSD backplane
f. Hard drive or SSD cage
g. PCIe extender or storage controller card
h. PCIe mezzanine card
i. IDSDM or rSPI card
j. NDC
k. SD vFlash card
l. Internal USB key
5. Install an I/O connector cover on the I/O connector(s) at the back of the board.
CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
CAUTION: You must temporarily label the hard drive or SSD before removal so that you can replace them in their
original locations.
NOTE: The processor and heat sink can become extremely hot. Be sure the processor has had sufficient time to cool
before handling.
NOTE: The memory modules are hot to the touch for some time after the system has been turned off. Allow time for the
memory modules to cool before handling them. Handle the memory modules by the card edges and avoid touching the
components.
1. Remove the screws on the system board that secure the system board to the chassis
2. Lift the system board by its back end and angle it upward.
3. Remove the system board from the chassis by disengaging the USB connectors from the slots on the front wall of the
chassis.
4. Ensure that the I/O connector cover is still in place on the I/O connector at the back of the board.
110
Installing and removing sled components