Owners Manual

Viewing System Setup
To view the System Setup screen, perform the following steps:
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
Related concepts
System Setup on page 25
Related references
System Setup details on page 26
System BIOS on page 26
iDRAC Settings utility on page 47
Device Settings on page 48
System Setup details
The System Setup Main Menu screen details are explained as follows:
Option
Description
System BIOS Enables you to configure BIOS settings.
iDRAC Settings Enables you to configure iDRAC settings.
The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI
(Unified Extensible Firmware Interface). You can enable or disable various iDRAC parameters by using the
iDRAC settings utility. For more information about this utility, see Integrated Dell Remote Access
Controller User’s Guide at Dell.com/idracmanuals.
Device Settings Enables you to configure device settings.
Related concepts
System Setup on page 25
Related tasks
Viewing System Setup on page 26
System BIOS
You can use the System BIOS screen to edit specific functions such as boot order, system password, setup password, set the
RAID mode, and enable or disable USB ports.
Related references
System BIOS Settings details on page 27
Boot Settings on page 28
Network Settings on page 30
System Security on page 31
System Information on page 35
Memory Settings on page 36
26
Pre-operating system management applications