Owners Manual

Figure 17. Installing the memory module
a. memory module
b. memory module socket
c. memory module ejector (2)
1. Follow the procedure listed in the After working inside your system section.
2. (Optional) Press F2 to enter the System Setup, and check the System Memory setting.
The system should have already changed the value to reflect the newly installed memory.
NOTE:
If the value is incorrect, one or more of the memory modules may not be installed properly. Check to ensure that
the memory modules are firmly seated in their sockets.
3. Run the system memory test in the system diagnostics.
Related references
Safety instructions on page 51
Related tasks
Before working inside your system on page 51
Removing memory modules on page 64
After working inside your system on page 52
PCIe mezzanine card
Your system supports x16 Gen 3 PCIe mezzanine card, which provides an interface between the sled and the PCIe switches on
the FX2s enclosure.
NOTE: Ensure that the PCIe mezzanine card is set to Enabled in System Setup.
Removing a PCIe mezzanine card
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in safety instructions section.
66
Installing and removing sled components