Owners Manual

4. If installed, remove the internal USB key.
5. If installed, remove the SD card(s).
1. Remove the two screws securing the IDSDM card to the system board.
2. Remove the SD card slot bracket.
CAUTION: To prevent damage to the IDSDM card, you must hold the card only by its edges.
3. Lift the card up and away from the system.
Figure 23. Removing the optional IDSDM card
1.
IDSDM card 2. screw (2)
3. SD card slot bracket 4. PCIe mezzanine card support bracket
5. IDSDM card connector on the system board 6. standoff (2)
1. Install the IDSDM card.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 51
Related tasks
Installing the optional IDSDM card on page 72
Before working inside your system on page 51
Replacing the internal USB key on page 70
Replacing an SD card on page 69
After working inside your system on page 52
Installing the optional IDSDM card
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
72 Installing and removing sled components