Owners Manual

Replacing the internal USB key on page 70
Replacing an SD card on page 69
After working inside your system on page 52
rSPI card (optional)
rSPI (restore Serial Peripheral Interface) is a SPI flash device to store information about the system Service Tag, system
configuration, or iDRAC license.
Removing the optional rSPI card
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in the Before working inside your system section.
1. Remove the two screws securing the rSPI card to the system board.
CAUTION: To prevent damage to the rSPI card, you must hold the card only by its edges.
2. Lift the card up and away from the system.
Figure 25. Removing the optional rSPI card
1.
screw (2) 2. rSPI card
3. standoff (2) 4. connector
1. Install the rSPI card.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 51
74
Installing and removing sled components