Owners Manual

Related references
Safety instructions on page 51
Related tasks
Removing a PCIe mezzanine card on page 66
Removing the Network Daughter Card on page 77
Installing a PCIe mezzanine card on page 67
After working inside your system on page 52
Processors
Your system supports one or two Intel Xeon E5-2600 v3 or E5-2600 v4 product family processors.
CAUTION: For processors of 105 W, 120 W, or 135 W, use heat sinks of 68 mm width.
CAUTION: For processors of 105 W (for acoustic configuration), 135 W (four cores, six cores, or eight cores), or
145 W, use heat sinks of 104 mm width.
NOTE: Mixing processors of different wattages is not supported.
Use the following procedure when:
● Removing and installing a heat sink
● Installing an additional processor
● Replacing a processor
NOTE: To ensure proper system cooling, you must install a processor blank in any empty processor socket.
Related tasks
Removing a heat sink on page 80
Removing a processor on page 81
Installing a processor on page 84
Installing a heat sink on page 85
Removing a heat sink
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
CAUTION: Never remove the heat sink from a processor unless you intend to remove the processor. The heat
sink is necessary to maintain proper thermal conditions.
NOTE: The processor and heat sink can become extremely hot. Be sure the processor has had sufficient time to cool
before handling.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in the Before working inside your system section.
4. Remove the cooling shroud.
1. Loosen the first screw that secures the heat sink to the system board.
Allow some time (around 30 seconds) for the heat sink to loosen from the processor.
2. Loosen the screw that is diagonally opposite the screw you first removed.
3. Repeat the procedure for the remaining two screws.
80
Installing and removing sled components