Owners Manual

Figure 33. Installing and removing a processor
1.
socket-release lever 1 2. pin–1 corner of the processor
3. processor 4. slot (4)
5. processor shield 6. socket-release lever 2
7. processor socket 8. tab (4)
Enter an example that illustrates the current task (optional).
1. Replace the processor(s).
2. Install the heat sink.
3. Reinstall the cooling shroud.
4. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 51
Related tasks
Before working inside your system on page 51
Installing the cooling shroud on page 56
Removing a heat sink on page 80
Installing a processor on page 84
Installing a heat sink on page 85
Removing the cooling shroud on page 56
After working inside your system on page 52
Installing and removing sled components
83