User Manual

NOTE: When creating an interface range, interfaces appear in the order they were entered and are
not sorted.
To display all interfaces that have been validated under the interface range context, use the show range
in Interface Range mode.
To display the running configuration only for interfaces that are part of interface range, use the show
configuration command in Interface Range mode.
Bulk Configuration Examples
The following are examples of using the interface range command for bulk configuration:
• Create a Single-Range
• Create a Multiple-Range
• Exclude a Smaller Port Range
• Overlap Port Ranges
• Commas
Create a Single-Range
Creating a Single-Range Bulk Configuration
Dell(conf)# interface range tengigabitethernet 0/1 - 5
Dell(conf-if-range-te-0/1-5)# no shutdown
Dell(conf-if-range-te-0/1-5)#
Create a Multiple-Range
Creating a Multiple-Range Prompt
Dell(conf)#interface range tengigabitethernet 0/5 - 10 , tengigabitethernet
0/1 , vlan 1
Dell(conf-if-range-te-0/5-10,te-0/1,vl-1)#
Exclude a Smaller Port Range
If the interface range has multiple port ranges, the smaller port range is excluded from the prompt.
Interface Range Prompt Excluding a Smaller Port Range
Dell(conf)#interface range tengigabitethernet 0/1 - 2 , tengigab 0/1 - 7
Dell(conf-if-range-te-0/1-7)#
Overlap Port Ranges
If overlapping port ranges are specified, the port range is extended to the smallest start port number and
largest end port number.
Interface Range Prompt Including Overlapping Port Ranges
Dell(conf)#inte ra tengig 0/1 - 3 , tengig 0/1 - 7
Dell(conf-if-range-te-0/1-7)#
Interfaces
103