User Manual

show interface status Command Example:
Dell# show interfaces status
Port Description Status Speed Duplex Vlan
Te 0/1 Up 10000 Mbit Full 1-4094
Te 0/2 Down Auto Auto 1-1001,1003-4094
Te 0/3 Up 10000 Mbit Full 1-1001,1003-4094
Te 0/4 Down Auto Auto 1-1001,1003-4094
Te 0/5 Up 10000 Mbit Full 1-4094
Te 0/6 Up 10000 Mbit Full 1-4094
Te 0/7 Up 10000 Mbit Full 1-4094
Te 0/8 toB300 Down Auto Auto 1-1001,1003-4094
Fc 0/9 Up 8000 Mbit Full --
Fc 0/10 Up 8000 Mbit Full --
Te 0/11 Down Auto Auto --
Te 0/12 Down Auto Auto --
In the above example, several ports display “Auto” in the speed field, including port 0/1. Now, in the below
example, the speed of port 0/1 is set to 100 Mb and then its auto-negotiation is disabled.
Setting Port Speed Example
Dell#configure
Dell(conf)#interface tengig 0/1
Dell(conf-if-te-0/1)#speed 1000
Dell(conf-if-te-0/1)#no negotiation auto
Dell(conf-if-te-0/1)#show config
!
interface TenGigabitEthernet 0/1
speed 1000
no shutdown
Setting Auto-Negotiation Options
Auto-Negotiation, Speed, and Duplex Settings on Different Optics:
Command Mode 10GbaseT
module
10G SFP+
optics
1G SFP optics Copper SFP
- 1000baseT
Comments
speed 100 interface-
config
mode
Supported Not
supported(
Error
message is
thrown) (%
Error:
Speed 100
not
supported
on this
interface,
config
ignored Te
0/49)
Not
supported(Error
message is
thrown) (% Error:
Speed 100 not
supported on this
interface, config
ignored Te 0/49)
% Error:
Speed 100
not
supported
on this
interface,
108
Interfaces