User Manual

Table 8. Output Field Descriptions for show link-bundle-distribution port-channel Command
Field Description
Link-bundle trigger threshold Threshold value that is the checkpoint, exceeding
which the link bundle is marked as being
overutilized and alarm is generated
LAG bundle number Number of the LAG bundle
Utilization (In Percent) Traffic usage in percentage of the packets
processed by the port channel
Alarm State Indicates whether an alarm is generated if over-
utilization of the port channel occurred. The value,
Active, is displayed for this field.
Interface Slot and port number, and the type of the member
interface of the port channel
Line Protocol Indicates whether the interface is administratively
up or down
Utilization (In Percent) Traffic usage in percentage of the packets
processed by the particular member interface
You can also use the show running-configuration interface port-channel command in EXEC
Privilege mode to view whether the mechanism to evaluate the utilization of the member interfaces of
the LAG bundle is enabled. The following sample output illustrates the portion of this show command:
Dell#show running-config int port-channel 1
!
interface Port-channel 1
mtu 12000
portmode hybrid
switchport
vlt-peer-lag port-channel 1
no shutdown
link-bundle-monitor enable
Verifying LACP Operation and LAG Configuration
To verify the operational status and configuration of a dynamically created LAG, and LACP operation on a
LAG on an Aggregator, enter the show interfaces port-channel port-channel-number and
show lacp port-channel-number commands.
The show outputs in this section for uplink LAG 128 and server-facing LAG 1 refer to the LACP Operation
on an Aggregator figure
show interfaces port-channel 128Command Example
Dell# show interfaces port-channel 128
Port-channel 128 is up, line protocol is up
Created by LACP protocol
Hardware address is 00:01:e8:e1:e1:c1, Current address is 00:01:e8:e1:e1:c1
Interface index is 1107755136
Minimum number of links to bring Port-channel up is 1
Internet address is not set
Mode of IP Address Assignment : NONE
DHCP Client-ID :lag1280001e8e1e1c1
MTU 12000 bytes, IP MTU 11982 bytes
130
Link Aggregation