User Manual

CLI Command Mode Prompt Access Command
CONFIGURATION
Dell(conf)#
• From EXEC privilege mode,
enter the configure
command.
• From every mode except
EXEC and EXEC Privilege,
enter the exit command.
NOTE: Access all of the
following modes from
CONFIGURATION mode.
10 Gigabit Ethernet Interface
Dell(conf-if-te-0/1)#
interface (INTERFACE modes)
Interface Range
Dell(conf-if-range)#
interface (INTERFACE modes)
Management Ethernet Interface
Dell(conf-if-ma-0/0)#
interface (INTERFACE modes)
MONITOR SESSION
Dell(conf-mon-sess)# monitor session
IP COMMUNITY-LIST
Dell(config-community-
list)#
ip community-list
CONSOLE
Dell(config-line-
console)#
line (LINE Modes)
VIRTUAL TERMINAL
Dell(config-line-vty)#
line (LINE Modes)
The following example shows how to change the command mode from CONFIGURATION mode to
INTERFACE configuration mode.
Example of Changing Command Modes
Dell(conf)#interface tengigabitethernet 0/2
Dell(conf-if-te-0/2)#
The do Command
You can enter an EXEC mode command from any CONFIGURATION mode (CONFIGURATION,
INTERFACE, and so on.) without having to return to EXEC mode by preceding the EXEC mode command
with the
do command.
The following example shows the output of the do command.
Dell(conf)#do show system brief
Stack MAC : 00:1e:c9:de:03:7b
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version
Ports
--------------------------------------------------------------------------------
----
0 Management online PE-FN-410S-IOA PE-FN-410S-IOA 1-0(0-1864)
12
1 Member not present
2 Member not present
3 Member not present
22
Configuration Fundamentals