User Manual

ManualsBrandsDell ManualsComputer HardwarePowerEdge FX2/FX2s

241

242

243

244

245

246

247

248

249

250

Dell_VLTpeer1(conf-if-po-110)#vlt-peer-lag port-channel 110

Dell_VLTpeer1(conf-if-po-110)#end

Verify that the port channels used in the VLT domain are assigned to the same VLAN.

Dell_VLTpeer1# show vlan id 10

Codes: * - Default VLAN, G - GVRP VLANs, P - Primary, C - Community, I -

Isolated

Q: U - Untagged, T - Tagged

x - Dot1x untagged, X - Dot1x tagged

G - GVRP tagged, M - Vlan-stack, H - Hyperpull tagged

NUM Status Description Q Ports

10 Active U Po110(Te 0/5)

T Po100(Te 0/6,7)

Configuring Virtual Link Trunking (VLT Peer 2)

Configure the backup link.

Dell_VLTpeer2(conf)#interface ManagementEthernet 0/0

Dell_VLTpeer2(conf-if-ma-0/0)#

ip address 10.11.206.35/

Dell_VLTpeer2(conf-if-ma-0/0)#no shutdown

Dell_VLTpeer2(conf-if-ma-0/0)#exit

Configure the VLT interconnect (VLTi).

Dell_VLTpeer2(conf)#interface port-channel 100

Dell_VLTpeer2(conf-if-po-100)#channel-member TenGigE 0/3,4

Dell_VLTpeer2(conf-if-po-100)#no shutdown

Dell_VLTpeer2(conf-if-po-100)#exit

Enable VLT and create a VLT domain with a backup-link VLT interconnect (VLTi).

Dell_VLTpeer2(conf)#vlt domain 999

Dell_VLTpeer2(conf-vlt-domain)#peer-link port-channel 100

Dell_VLTpeer2(conf-vlt-domain)#back-up destination 10.11.206.23

Dell_VLTpeer2(conf-vlt-domain)#exit

Configure the port channel to an attached device.

Dell_VLTpeer2(conf)#interface port-channel 110

Dell_VLTpeer2(conf-if-po-110)#switchport

Dell_VLTpeer2(conf-if-po-110)#channel-member TenGigE 0/8

Dell_VLTpeer2(conf-if-po-110)#no shutdown

Dell_VLTpeer2(conf-if-po-110)#vlt-peer-lag port-channel 110

Dell_VLTpeer2(conf-if-po-110)#end