User Manual

Step Task Command Command Mode

Enable the port for FC transmission.

no shutdown

INTERFACE

FIBRE_CHANNEL

Important Points to Remember

You can apply a DCB or FCoE map to a range of Ethernet or Fibre Channel interfaces by using the

interface range command; for example:

Dell(config)# interface range tengigabitEthernet 1/12 - 23 , tengigabitEthernet

2/24 - 35

Dell(config)# interface range fibrechannel 0/0 - 3 , fibrechannel 0/8 - 11

Enter the keywords interface range followed by an interface type and port range. A port range must

contain spaces before and after the dash. Separate each interface type and port range with a space,

comma, and space as shown in the preceding examples.

Sample Configuration

1. Configure a DCB map with PFC and ETS settings:

Dell(config)# dcb-map SAN_DCB_MAP

Dell(config-dcbx-name)# priority-group 0 bandwidth 60 pfc off

Dell(config-dcbx-name)# priority-group 1 bandwidth 20 pfc on

Dell(config-dcbx-name)# priority-group 2 bandwidth 20 pfc on

Dell(config-dcbx-name)# priority-group 4 strict-priority pfc off

Dell(conf-dcbx-name)# priority-pgid 0 0 0 1 2 4 4 4

2. Apply the DCB map on a downstream (server-facing) Ethernet port:

Dell(config)# interface tengigabitethernet 1/0

Dell(config-if-te-0/0)#dcb-map SAN_DCB_MAP

3. Create the dedicated VLAN to be used for FCoE traffic:

Dell(conf)#interface vlan 1002

4. Configure an FCoE map to be applied on downstream (server-facing) Ethernet and upstream (core-

facing) FC ports:

Dell(config)# fcoe-map SAN_FABRIC_A

Dell(config-fcoe-name)# fabric-id 1002 vlan 1002

Dell(config-fcoe-name)# description "SAN_FABRIC_A"

Dell(config-fcoe-name)# fc-map 0efc00

NPIV Proxy Gateway

259