User Manual

Dell(config-fcoe-name)# keepalive
Dell(config-fcoe-name)# fcf-priority 128
Dell(config-fcoe-name)# fka-adv-period 8
5. Enable an upstream FC port:
Dell(config)# interface fibrechannel 0/0
Dell(config-if-fc-0)# no shutdown
6. Enable a downstream Ethernet port:
Dell(config)#interface tengigabitEthernet 0/0
Dell(conf-if-te-0)# no shutdown
Displaying NPIV Proxy Gateway Information
To display information on the NPG operation, use the show commands in the following table:
Table 21. Displaying NPIV Proxy Gateway Information
Command Description
show interfaces status
Displays the operational status of Ethernet and Fibre Channel
interfaces on the Aggregator with the NPG.
NOTE: Although the show interface status command
displays the Fiber Channel (FC) interfaces with the
abbreviated label of 'Fc' in the output, if you attempt to
specify a FC interface by using the interface fc
command in the CLI interface, an error message is
displayed. You must configure FC interfaces by using the
interface fi command in CONFIGURATION mode.
show fcoe-map [brief | map-
name]
Displays the Fibre Channel and FCoE configuration
parameters in FCoE maps. Enter the brief keyword to display
an overview of currently configured FCoE maps.
Enter the name of an FCoE map to display the FC and FCoE
parameters configured in the map to be applied on the
Aggregator with the FC ports.
show qos dcb-map
map-name
Displays configuration parameters in a specified DCB map.
show npiv devices [brief]
Displays information on FCoE and FC devices currently logged
in to the NPG.
show fc switch
Displays the FC mode of operation and worldwide node
(WWN) name of an Aggregator.
show interfaces status Command Example
Dell# show interfaces status
Port Description Status Speed Duplex Vlan
260
NPIV Proxy Gateway