User Manual

Slot range: 0-0
To configure an IP address on a management interface, use either of the following commands in
MANAGEMENT INTERFACE mode:
Command Syntax Command Mode Purpose
ip address ip-address mask INTERFACE Configure an IP address and mask on
the interface.
• ip-address mask: enter an address in
dotted-decimal format (A.B.C.D),
the mask must be in /prefix format
(/x)
ip address dhcp INTERFACE Acquire an IP address from the DHCP
server.
To access the management interface from another LAN, you must configure the management route
command to point to the management interface.
There is only one management interface for the whole stack.
To display the routing table for a given port, use the show ip route command from EXEC Privilege
mode.
Configuring a Static Route for a Management Interface
When an IP address used by a protocol and a static management route exists for the sample prefix, the
protocol route takes precedence over the static management route.
To configure a static route for the management port, use the following command in CONFIGURATION
mode:
Command Syntax Command Mode Purpose
management route ip-address
mask {forwarding-router-address |
ManagementEthernet slot/port}
CONFIGURATION Assign a static route to point to the
management interface or forwarding router.
To view the configured static routes for the management port, use the show ip management-route
command in EXEC privilege mode.
Dell#show ip management-route all
Destination Gateway State Route Source
----------- ------- ----- ------------
10.11.0.0/16 ManagementEthernet 0/0 Connected Connected
Dell#
Interfaces
95