Manual
Table Of Contents
- Contents
- About this document
- Introducing the SAN I/O Module
- Configuring the SAN I/O Module
- Items required
- Modify the SAN I/O Module IP address
- Connecting the SAN I/O Module to the Ethernet network
- Connecting the SAN I/O Module to the fabric
- Changing from Fabric OS Native to Access Gateway mode
- Changing from Access Gateway mode to Fabric Switch mode
- Activating Ports on Demand (POD)
- Connecting to the SAN I/O Module Using Web Tools
- Operating the SAN I/O Module
- Interoperability
- Accessing the SAN I/O Module
- Interpreting POST results
- Interpreting LED activity
- Removing and replacing the SAN I/O Module
- Access Gateway Mode default port mapping
- Processor and memory specifications
- Weight and physical dimensions
- Facility requirements
- Electrical
- Architectural specification
- Supported HBAs
- Fibre Channel standards compliance
- Regulatory compliance
- Environmental regulation compliance
- Index
M5424 SAN I/O Module Hardware Reference Manual 3
53-1001082-01
Fabric OS Native and Access Gateway modes
1
NOTE
You can also install 4 Gbps SFPs in the SAN I/O Module, however all SFPs must be
Brocade-branded.
• One serial console port on the front panel (RJ45 connector).
• One green/amber LED to indicate status for each port.
If dark, the port is unlicensed.
• The following system light-emitting diodes (LEDs):
- One green power LED to indicate module power-on.
- One green/amber LED to indicate module status.
- One blue, identify module and flash blue to locate module.
See “Interpreting LED activity” on page 22 for details about the SAN I/O Module LEDs.
Ports on Demand (POD)
The SAN I/O Module ships with a specific number of active ports. You can allocate a POD license to
activate additional ports. The SAN I/O Module supports two licensing methods: static and dynamic
(module default).
• For Dynamic POD, 12 licenses are available for the first 12 active ports. Ports 17 and 18 are
licensed at the factory. The remaining 10 licenses are assigned to active ports as required.
Once licenses are issued, they can be moved from one port to another, making port licensing
more flexible.
• For static POD, Table 1 shows the base internal and external ports that are licensed, as well as
the additional 12 ports that can be activated with a POD license. For details about activating
and deactivating additional ports when you have POD licensing, refer to
“Activating Ports on
Demand (POD)” on page 17.
TABLE 1 Ports available
Port Licensing External Ports Internal Ports
Base 17, 18, 19, and 20 1, 2, 3, 4, 5, 6, 7, and
8
POD 0, 21, 22, and 23 9, 10, 11, 12, 13, 14,
15, and 16