Manual
Table Of Contents
- Contents
- About this document
- Introducing the SAN I/O Module
- Configuring the SAN I/O Module
- Items required
- Modify the SAN I/O Module IP address
- Connecting the SAN I/O Module to the Ethernet network
- Connecting the SAN I/O Module to the fabric
- Changing from Fabric OS Native to Access Gateway mode
- Changing from Access Gateway mode to Fabric Switch mode
- Activating Ports on Demand (POD)
- Connecting to the SAN I/O Module Using Web Tools
- Operating the SAN I/O Module
- Interoperability
- Accessing the SAN I/O Module
- Interpreting POST results
- Interpreting LED activity
- Removing and replacing the SAN I/O Module
- Access Gateway Mode default port mapping
- Processor and memory specifications
- Weight and physical dimensions
- Facility requirements
- Electrical
- Architectural specification
- Supported HBAs
- Fibre Channel standards compliance
- Regulatory compliance
- Environmental regulation compliance
- Index
12 M5424 SAN I/O Module Hardware Reference Manual
53-1001082-01
Modify the SAN I/O Module IP address
2
• Switch-6 for SAN I/O module installed in bay C2.
3. At the login prompt, enter the user name as admin and password as password.
4. Use the appropriate CLI commands to change the IP address of the selected SAN I/O module.
Refer to your Blade Server Enclosure CLI documentation.
Using the CMC GUI to set the IP address
To change the IP address, use the following steps:
1. Open the CMC application’s Setup tab.
2. Enter the new information in the IP Address, Subnet Mask, and Gateway fields as appropriate
and click Apply.
3. To enable DHCP, select DHCP Enabled and click Apply.
FIGURE 4 CMC Setup tab
NOTE
Refer to the documentation for the CMC GUI application for additional detail.