Manual
Table Of Contents
- Contents
- About this document
- Introducing the SAN I/O Module
- Configuring the SAN I/O Module
- Items required
- Modify the SAN I/O Module IP address
- Connecting the SAN I/O Module to the Ethernet network
- Connecting the SAN I/O Module to the fabric
- Changing from Fabric OS Native to Access Gateway mode
- Changing from Access Gateway mode to Fabric Switch mode
- Activating Ports on Demand (POD)
- Connecting to the SAN I/O Module Using Web Tools
- Operating the SAN I/O Module
- Interoperability
- Accessing the SAN I/O Module
- Interpreting POST results
- Interpreting LED activity
- Removing and replacing the SAN I/O Module
- Access Gateway Mode default port mapping
- Processor and memory specifications
- Weight and physical dimensions
- Facility requirements
- Electrical
- Architectural specification
- Supported HBAs
- Fibre Channel standards compliance
- Regulatory compliance
- Environmental regulation compliance
- Index
24 M5424 SAN I/O Module Hardware Reference Manual
53-1001082-01
Removing and replacing the SAN I/O Module
3
FIGURE 6 Removing an SFP from a Port
5. Refer to the Hardware Owner’s Manual for the Blade Server Enclosure to remove and replace
the SAN I/O module from the enclosure.
.
ATTENTION
If you are not replacing the SAN I/O Module, use a filler panel to fill the empty slot to maintain proper
air flow. Do not leave the slot empty.
SFP
Bale
3
1
Cable
Release
2
SFP
4