Users Guide

The Lifecycle Controller Network Settings page is displayed.

Configuring Lifecycle Controller Network Settings

Use this page to configure network settings for a NIC.

1. Start Lifecycle Controller. For more information, see Starting Lifecycle Controller.

2. On the left pane, click Settings.

3. On the Settings pane, click Network Settings.

4. From the NIC Card drop-down menu, select the NIC port that you want to configure.

NOTE: You can use only one NIC at a time to communicate with the network.

5. From the IPV4 Network Settings→ IP Address Source drop-down menu, select one of the following

options:

• No Configuration — indicates that the NIC must not be configured.

• DHCP — indicates that the NIC must be configured using an IP address from a DHCP server. If

DHCP is selected, a DHCP IP address is displayed on the Network Settings page.

• Static IP — indicates that the NIC must be configured using a static IP. Type the IP Address

Properties — IP Address, Subnet Mask, Default Gateway, and DNS Address. If you do not have

this information, contact your network administrator.

6. Click Enabled and type the VLAN ID and Priority under Lifecycle Controller VLAN Settings to

configure the VLAN settings of a NIC.

You cannot configure the VLAN settlings of the following NICs:

• Emulex SeaHawk-2 (FH) PCIe Adapter

• Emulex SeaHawk-2 (LP) PCIe Adapter

• Emulex Vindicator-2 rNDC

• Emulex Sea Stallion-2 Mezzanine Card

• Emulex Pave Low-2 bNDC

• Emulex SeaHawk-2 (FH) NIC Only PCIe Adapter

• Emulex SeaHawk-2 (LP) NIC Only PCIe Adapter

• Emulex Vindicator-2 NIC Only rNDC

• Emulex Sea Stallion-2 NIC Only Mezzanine Card

• Emulex Pave Low-2 NIC Only bNDC

7. Click Next.

NOTE: If Lifecycle Controller settings are not correctly configured, an error message is

displayed.

NOTE: If you are unable to connect to a network, verify the settings. For information about

correct network settings, contact your network administrator.

Configuring iDRAC Network and Credentials

Use this page to configure remote access parameters for iDRAC.

1. From the IP Address Source menu, select one of the following options:

• Static — indicates that the network must be configured by using a static IP. Type the IP Address

Properties such as IP Address, Subnet Mask, Default Gateway, DNS Address Source, and DNS

Address. If you do not have this information, contact your network administrator.