Users Guide

NOTE: When you update the firmware on a BCM57xx and 57xxx adapters, you will notice that the
cards are displayed as QLogic. This is due to the acquisition of Broadcom NetXtreme II by QLogic.
The Advanced Hardware Configuration wizard allows you to configure the following:
NOTE: You can also use System Setup utility during startup to configure the following devices. For
more information about the System Setup utility, see Using The System Setup Program And Boot
Manager.
• System BIOS Settings
• iDRAC Device Settings
• NICs
You can configure only one NIC at a time. The supported NIC cards are as follows:
– BCM5708 TOE plus iSCSI Offload NIC
– BCM5709C Dual Port NIC without iSCSI Offload
– BCM5709C Dual Port Rack Mezzanine Card
– BCM5709S Dual Port SERDES Mezzanine Card for Blade Systems
– BCM57710 10GBase-T Single Port NIC
– BCM57710 10GBase-T Dual Port Rack Mezzanine Card
– BCM57710 Dual Port KX4 Blade Mezzanine Card
– BCM57711 Dual Port KX4 Noble MC
– BCM95708C PCI-E NIC
– BCM95709C 10/100/1000BASET Quad Port NIC
– BCM95709 iSCSI Offload Dual Port NIC
– BCM957711 10G SFP+ Dual Port NIC
– Broadcom 57810S DP 10G SFP+ Adapter (Full Height)
– Broadcom 57810S DP 10G SFP+ Adapter (Low Profile)
– Broadcom 57800S DP 10G BASE-T Adapter (Full Height)
– Broadcom 57800S DP 10G BASE-T Adapter (Low Profile)
– Broadcom 5720 DP 1G Adapter (Full Height)
– Broadcom 5720 DP 1G Adapter (Low Profile)
– Broadcom 5719 QP 1G Adapter (Full Height)
– Broadcom 5719 QP 1G Adapter (Low Profile)
– Broadcom 57800S QP rNDC (10G BASE-T + 1G BASE-T)
– Broadcom 57800S QP rNDC (10G SFP+ + 1G BASE-T)
– Broadcom 5720 QP rNDC 1G BASE-T
– Broadcom 57810S DP bNDC KR
– Broadcom 5719 QP 1G Mezz
– Broadcom 57810S DP 10G KR Mezz
– Intel(R) Ethernet Converged Network Adapter X710 (Dual Port)
– Intel(R) Ethernet Converged Network Adapter X710 (Quad Port)
– Intel(R) Ethernet 10G 4P X710/I350 rNDC
– Intel(R) Ethernet 10G 4P X710-k bNDC
– Intel(R) Ethernet 10G 4P X710 SFP+ rNDC
– Intel i540 DP 10G BASE-T Adapter (Full Height)
58