Users Guide

• H310 Embedded

• H330 Adapter

• H330 Mini Monolithic

• H330 Mini and Mono

• H330 Mini Blades

• H330 Embedded

• H710 Adapter

• H710 Mini Blades

• H710 Mini Monolithic

• H710P Adapter

• H710P Mini Blades

• H710P Mini Monolithic

• H810 Adapter

• H830 Adapter

• H730P Adapter

• PERC S110

• PERC S130

Integrated Broadcom NICs are controlled by both BIOS and the settings stored on the device itself. As a

result, the Boot Protocol field in the HII of integrated NICs has no effect; this setting is instead controlled

by the BIOS on the Integrated Devices screen.

To set integrated NICs to an iSCSI or PXE boot mode, select System BIOS Settings, and then select

Integrated Devices. In the list for each embedded NIC, select the appropriate value:

• Enabled for no boot capability.

• Enabled with PXE to use the NIC for PXE boot.

• Enabled with iSCSI to use the NIC to boot from an iSCSI target.

Modifying device settings

To modify device settings using the Advanced Hardware Configuration:

NOTE: You can also modify the device settings by using the System Setup utility during startup. For

more information about the System Setup utility, see Using The System Setup Program And Boot

Manager.

1. Start Lifecycle Controller. For more information, see Starting Lifecycle Controller.

2. In the left pane, select System Setup.

3. In the right pane, click Advanced Hardware Configuration.

4. Select the device you want to configure.

Based on the configuration setting changes, the following message may be displayed:

One or more of the settings requires a reboot to be saved and activated. Do

you want to reboot now?

5. Select No to continue making additional configuration changes or select Yes to save the changes

and exit the wizard.

All changes are applied during the next system restart.