Users Guide

To fix the issue, ioSphere needs to be reinstalled. The link below contains information about installing, updating and managing Fusion-IO,
which contains information about installing ioSphere:
http://www.dell.com/support/article/au/en/audhs1/sln156793/how-to-install-update-and-manage-fusion-io-drives-in-windows-os-on-
dell-poweredge-servers?lang=en
Symptoms
Dell PowerEdge Express Flash NVMe PCIe SSD device is not detected
during hot-plug in ESXi 6.0
Description
When the Express Flash NVMe PCIe SSD namespace is set as Offline and hot-plug operation is performed in the same slot, the SSD does
not initialize and is not detected.
This is a known issue. Perform one of the following steps:
1. Reconnect the drive to a different drive slot, if available.
2. Restart the sfcbd-watchdog service and reinsert the drive.
Linux
FAQs
Why are network ports displayed as unknown in YaST2 network
configuration in SUSE Linux Enterprise?
While configuring a bonding interface, the configured bond-slaves are listed as Unknown Network Device. The YaST installer is unable to
write the device name in to the ifcfg files. Delete the existing configuration of previously configured network interfaces.
Symptoms
Unable to boot from iSCSI when static IPv6 address is assigned to the
initiator
Description
The SUSE Linux Enterprise Server 12 does not boot from iSCSI over IPv6 address after successful installation, when static IPv6 address is
assigned to the initiator.
Resolution
Use Dynamic Host Configuration Protocol (DHCP) address for the initiator.
Installing operating system through various
methods
Install and deploy operating system through Dell Lifecycle Controller and various methods, watch the following videos listed below:
Table 22. Installation of OS through LC and various methods
Slno Video Description Location
1. Launching Lifecycle Controller Launching LC
2. Dell Lifecycle Controller - Firmware Rollback LC Firmware Rollback
Troubleshooting operating system issues 113