Hardware Owner's Manual

128 About Your System
Memory tests
terminated by
keystroke.
The spacebar or ESC key
was pressed during POST
to terminate the memory
test.
Information only.
Keyboard data line
failure.
Keyboard cable connector
loose or improperly
connected. Keyboard or
keyboard/mouse controller
may be faulty.
Ensure that the keyboard is
properly connected. If the
problem persists, see
"Getting Help" on page 361.
Keyboard stuck key
failure.
Keyboard fuse has
failed.
Overcurrent detected in
the keyboard connector.
See "Getting Help" on
page 361.
No boot device
available.
Faulty or missing diskette
drive, optical drive, or hard
drive.
Check the Integrated
Devices configuration
settings in the System Setup
program and ensure that the
controller for the boot
device is enabled. See "Using
the System Setup Program
and UEFI Boot Manager" on
page 137. Ensure that the
controller for the boot
device is enabled.
If the problem persists,
replace the drive. See "Hard
Drives" on page 267.
No boot sector on
hard-disk drive.
An operating system is not
on the hard drive.
Check the hard-drive
configuration settings in the
System Setup program. See
"Using the System Setup
Program
and UEFI Boot Manager" on
page 137.
No timer tick
interrupt.
Faulty blade board. See "Getting Help" on
page 361.
Not a boot
diskette.
Not a bootable diskette. Use a bootable diskette.
Table 1-27. Blade Messages
(continued)
Message Causes Corrective Actions