Hardware Owner's Manual

Using the System Setup Program and UEFI Boot Manager 143
SATA Settings Screen (PowerEdge M610, M610x)
Boot Settings Screen
Intel<R> QPI
Bandwidth Priority
Sets the bandwidth priority to compute.
Turbo Mode If supported by the processor(s), enables or disables Tu r b o
Mode.
C1E (M915 only) When set to Enabled, the processor switches to minimum
performance in the idle state.
C States (Enabled
default)
When set to Enabled, the processor(s) can operate in all
power states.
Processor X Family-
Model-Stepping
Displays the family and model number of each processor. A
submenu displays the core speed, the amount of cache
memory, and the number of cores of the processor(s).
Option Description
Embedded SATA
(ATA Mode default)
ATA Mode enables the integrated SATA controller. Off
disables the controller.
Port A
(Auto default)
Auto enables BIOS support for the device attached to
SATA port A. Off disables BIOS support for the device.
Port B
(Auto default)
Auto enables BIOS support for the device attached to
SATA port B. Off disables BIOS support for the device.
Option Description
Boot Mode (BIOS
default)
(PowerEdge M915, M910,
M710, M710HD, M610,
and M610x)
If the operating system supports Unified Extensible
Firmware Interface, set this option to UEFI. Setting this
field to BIOS allows compatibility with non-UEFI
operating systems.
NOTE: Setting this field to UEFI disables the Boot
Sequence, Hard-Disk Drive Sequence, and USB Flash Drive
Emulation Type fields.
Option Description