Hardware Owner's Manual

Installing Blade Components 221

Figure 3-25. Installing and Removing a Mezzanine Card - Half-Height Blades

If present, remove the connector cover from the mezzanine card bay.

NOTE: Hold the mezzanine card by its edges only.

Mezzanine cards are designed to fit in either card slot. Rotate the card to

align the connector on the bottom of the mezzanine card with the

corresponding socket on the blade board.

1 Fabric C mezzanine card slot 2 Fabric B mezzanine card slot

3 mezzanine card 4 mezzanine card connector

5 retention latch