Hardware Owner's Manual

224 Installing Blade Components

PowerEdge M915, M910, M710, M710HD, M610, and M610x

In these blades, the SD card is an unmanaged persistent storage card. A

hypervisor may be installed using this card.

NOTE: For PowerEdge M915, M910, and M710HD, the iDRAC6 vFLASH card can be

set to IDSDM function along with the SD card by setting the Redundancy option to

Mirror mode in the Integrated Devices screen of system setup. When the IDSDM

function is enabled, the vFlash functionality of the iDRAC6 vFlash card gets

disabled.

NOTE: In IDSDM (PowerEdge M915, M910, and M710HD only), the SD card in the

lower card slot is the primary card (SD1) and the SD card in upper card slot is the

secondary card (SD2).

Remove the blade. See "Removing a Blade" on page 155.

Install the

card in the lower card slot. See Figure 3-27.

Install the blade. See "Installing a Blade" on page 158.

Figure 3-27. Installing and Removing an SD Card (PowerEdge M915, M910, M710,

M710HD, M610, and M610x)

1 SD card in lower card slot 2 iDRAC6 Enterprise card