Hardware Owner's Manual

Installing Blade Components 225

SD vFlash Card (PowerEdge M915, M910, M710,

M710HD, M610, and M610x Only)

NOTE: For PowerEdge M915, M910 and M710HD, the iDRAC6 vFLASH card can be

set to IDSDM function along with the SD card by setting the Redundancy option to

Mirror mode in the Integrated Devices screen of system setup. When the IDSDM

function is enabled, the vFlash functionality of the iDRAC6 vFlash card gets

disabled.

NOTE: In IDSDM (PowerEdge M915, M910, and M710HD only), the SD card in the

lower card slot is the primary card (SD1) and the SD card in upper card slot is the

secondary card (SD2).

The SD vFlash card plugs into the iDRAC6 Enterprise card at the back corner

of the blade.

Remove the blade. See "Removing a Blade" on page 155.

Install the

SD vFlash

card in the upper card slot. See Figure 3-28.

Install the blade. See "Installing a Blade" on page 158.

Figure 3-28. Installing and Removing an SD vFlash Card (PowerEdge M915, M910,

M710, M710HD, M610, and M610x)

1 SD vFlash card in upper card slot 2 iDRAC6 Enterprise card