Hardware Owner's Manual

Installing Blade Components 273
Figure 3-59. Removing and Installing a Video Controller Daughter Card (PowerEdge
M605 Shown)
4 To install a new video controller:
•
If you are installing a video controller in a PowerEdge M600 , align the
edge connector on the riser card with the connector on the system
board, and then lower the riser card into place until the connector is
fully seated and the latch snaps into place. See Figure 3-58.
•
If you are installing a video controller in a PowerEdge M605 , align the
connector on the underside of the controller card with the connector
on the system board, and then lower the card into place. Secure the
card with the two screws. See Figure 3-59.
1 video controller board 2 torx screws (2)
3 connector on system board
1
2
3