Hardware Owner's Manual

294 Installing Enclosure Components

Installing an SD Card in the CMC Module

The SD card slot on the CMCM module supports an optional WWN/MAC

feature that allows slot-based WWN/MACs for the blades, simplifying blade

installation and replacement.

NOTE: For a redundant CMC module system, install the SD card on the passive

module. The blue status indicator is off on the passive module.

Remove the CMC module from the M1000e enclosure. See "Removing a

CMC Module" on page 293.

NOTE: Verify the write protection latch is in the "unlock" position.

Locate the SD card slot on the bottom of the CMC module and insert the

contact-pin end of the card into the slot with the label on the card facing

upwards. See Figure 4-5.

Figure 4-5. Installing an SD Card in the CMC Module

1 SD card 2 SD card connector