Owners Manual

2. Remove the module from Fabric A or B slot.
Steps
1. Align and insert the blank in the empty slot.
2. Push the blank, until it locks into place.
Figure 29. Installing a blank in Fabric A or B slot
Removing a module from Fabric A or B slot
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Disconnect the cables that are connected to the modules.
Steps
1. Press the orange release button on the module to open the release levers.
2. Hold the release levers, and pull the module out of the enclosure.
NOTE: Ensure that you install an IOM blank if you are removing a module permanently.
40 Installing and removing system components