Owners Manual

Removing a management module

Prerequisites

1. Follow the safety guidelines listed in Safety instructions.

2. Disconnect the cables that are connected to the modules.

Steps

1. Press the orange release button on the module to open the release lever.

2. Hold the release lever, and pull the management module out of the enclosure.

NOTE: Ensure that you install a IOM blank if you are removing a module permanently.

Figure 38. Removing a management module

Next steps

1. Install the management module or Install a blank.

2. Connect the network cables to the module.

Disabling a forgotten Management Module password

The software security feature of the system includes a Management Module password. The Management Module password jumper

enables or disables Management Module password features and clears any Management Module passwords in use.

Prerequisites

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform troubleshooting and

simple repairs as authorized in your product documentation, or as directed by the online or telephone service and

support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow

the safety instructions that are shipped with your product.

Steps

1. Power off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2. Remove the Management Module.

3. Move the jumper on the Management Module from pins 2 and 3 to pins 1 and 2.

Installing and removing system components