Manualshelf

Users Guide

ManualsBrandsDell ManualsC SeriesPowerEdge MX7000
21222324252627282930
To configure the Quick Deploy settings:
1. Click Devices > Chassis > View Details > Settings > Quick Deploy.
The Quick Deploy configuration section is expanded.
2. Enter and confirm the password to access the iDRAC user interface.
The password can be up to 20 characters in length.
NOTE: If any iDRAC IP configuration is modified, the SSO for the SLEDs is functional from the OME-Modular console
only after the default inventory task or manual inventory refresh is complete.
3. In the Management IP section, select IPv4 Enabled to enable the IPv4 network settings and select the IPv4 Network
Type.
The available options are:
● Static
● DHCP
4. Enter the IPv4 Subnet Mask and IPv4 Gateway.
NOTE: The IPv4 Subnet Mask and IPv4 Gateway options are displayed only if the IPv4 Network Type is "Static".
5. Select IPv6 Enabled to enable the IPv6 network settings and select the IPv6 Network Type.
The available options are:
● Static
● DHCP
6. If the IPv6 Network Type is Static, select the IPv6 Prefix Length and enter the IPv6 Gateway.
7. From the list of slots that is displayed, select the check box next to the slot number to which you want to apply the Quick
Deploy settings.
8. In the Network IOM Settings section, enter and confirm the password to log in to the IOM interface.
9. Select IPv4 Enabled to enable the IPv4 network settings and select the IPv4 Network Type.
The available options are:
● Static
● DHCP
10. Enter the IPv4 Subnet Mask and IPv4 Gateway.
NOTE: The IPv4 Subnet Mask and IPv4 Gateway options are displayed only if the IPv4 Network Type is "Static".
11. Select IPv6 Enabled to enable the IPv6 network settings and select the IPv6 Network Type.
The available options are:
● Static
● DHCP
12. If the IPv6 Network Type is Static, select the IPv6 Prefix Length and enter the IPv6 Gateway.
13. Click Apply to save the Quick Deploy settings.
Managing chassis
You can view the list of chassis and the chassis details on the Chassis page. The details are—health, power state, name, IP
address, service tag, and model of the chassis. You can also select a chassis to view the graphical representation and summary
of the chassis, on the right side of the Chassis page.
You can also perform the following tasks on the Chassis page:
● Control chassis power
● Update firmware
● Blink LED
● Refresh chassis inventory
● Filter the chassis list
30
Logging in to OME-Modular