Manualshelf

Users Guide

ManualsBrandsDell ManualsC SeriesPowerEdge MX7000
51525354555657585960
NOTE: If Enable Authentication is selected, you must provide the user name and password to access the SMTP
server.
5. Enter SMTP Port Number.
6. If the SMTP server is configured to use SSL, select the SSL option.
Configuring SNMP alerts
The SNMP alerts contain the service tag of the chassis as one of the parameters in the trap. Third-party consoles can use this
information to correlate the traps with the system.
For network IOMs and compute sleds, OME–Modular subscribes to alerts through internal private VLANs—SNMP or REST. For
MXG610s fiber channel switching modules, only SNMP V1 is supported and you can configure only four SNMP alert destinations.
You can configure the SNMP alert destination for IOMs from the Application Settings > Alerts > SNMP Configuration
page. After configuring the SNMP destination, go to I/O Settings > Replicate Alert Destinations.
To configure SNMP alerts, perform the following steps:
1. From the main menu, select Application Settings > Alerts.
2. Click SNMP Configuration.
3. Select Enable to enable the configuration.
4. Enter the Destination Address.
You can configure up to four SNMP destinations.
5. Select the SNMP Version.
The available SNMP versions are:
● SNMP V1
● SNMP V2
NOTE: For MX9116n or MX5108n IOMs, only SNMP V2, is supported.
NOTE: The MX7000 chassis facilitates configuration of four SNMP destinations. However, the MXG610s FC IOM
switches support only three SNMP destinations. If the fourth SNMP destination is configured, the IOM ignores it.
6. Enter the Community String.
When you configure the community string for SNMP V1, by default, the community string is appended with |common|
FibreChannel11.
7. Select the Port Number and click Send to test the SNMP trap.
Configuring sys log alerts
You can configure up to four sys log destinations.
To configure system log alerts, perform the following steps:
1. Click Application Settings > Alerts > Syslog Configuration.
2. Select the Enabled check box corresponding to the required server.
3. Enter the destination address or the hostname.
4. Enter the port number.
52
Logging in to OME-Modular