Users Guide

3. Enter the IP Address, Subnet Mask, and Gateway for the management port.

The IP Address, Subnet Mask, and Gateway options are enabled only if the Enable DHCP check box is cleared.

NOTE: For MX5108n and MX9116n IOMs, the default prefix length of the DHCP IP is 128 bits, though the DHCP server

is configured for 64 bits.

4. In the IPv6 Settings section, select Enable IPv6.

5. Enter the IPv6 Address, select the Prefix Length.

The IPv6 Address, Prefix Length, and Gateway options are enabled only if the Enable Autoconfiguration check box is

cleared.

6. Enter the Gateway for the management port.

The IPv6 Address, Prefix Length, and Gateway options are enabled only if the Enable Autoconfiguration check box is

cleared.

NOTE: For tagged or untagged VLAN network, any IPv6 setting configured using OME - Modular may not have the

default gateway. To get the default gateway, go to the respective OS10 CLI and enable Stateless Address

Autoconfiguration (SLAAC) on the respective tagged or untagged VLAN.

7. In the DNS Server Settings section, enter the Preferred DNS Server, Alternate DNS Server 1, and Alternate DNS

Server 2 addresses.

For MXG610s IOMs, you can set the Preferred DNS and Alternate Server 1 and 2 addresses. However, the server address for

Alternate DNS Server 2 is not applied though the response is successful as, MXG610s IOMs support only two server

address for DNS settings.

8. In the Management VLAN section, select Enable VLAN and enter the VLAN ID.

For MXG610s FC IOMs, DHCP works only without VLAN while Static IP works with or without VLAN configuration. To

change the IP configuration from DHCP IP to Static IP, perform the following steps:

a. Disable DHCP, configure the static IP, and save the configuration.

b. Enable VLAN, configure the VLAN ID, and save the configuration.

Configuring IOM management settings

The management settings for IOMs include configuring the hostname and password of the management system.

1. Click All Devices > I/O Modules > View Details > Settings > Management or Devices > I/O Modules > View Details >

Settings > Management.

2. In the Host Name section, enter the name of the management system.

If you modify the hostname settings in the OME-Modular web interface for Fibre Channel IOM, the modified hostname for

Fibre Channel IOMs is displayed only in a new session. To see the modified hostname, log out and log in back to the session.

3. Enter the password to access the management system.

NOTE:

For Ethernet IOMs with OS10 version 10.5.0.7 and later and MXG610s, it sets the admin account password. For

OS10 versions earlier than 10.5.0.7, it sets the linux admin account password.

NOTE: The OS10 password length must be with minimum 9 characters. It is recommended to have at least one upper

case, one lower case, one numeric character and one special character for stronger password. By default, the minimum

number of different character settings are set as 0. You can use password-attributes command to configure desired

password strength.

4. Click Apply to save the management settings or click Discard to clear the changes and go back to the previous settings.

Configuring IOM monitoring settings

The monitoring settings for IOMs include configuring the settings to monitor SNMP..

1. Click All Devices > I/O Modules > View Details > Settings > Monitoring or Devices > I/O Modules > View Details >

Settings > Monitoring.

2. Select theEnable SNMP checkbox to enable of disable the SNMP.

3. From SNMP Version, select SNMP v1 or SNMP v2.

Ethernet IO Modules