Users Guide

4. Enter the Read Community String to fetch requests from the OME Modular daemon directed at the IOM.
5. Click Apply to save the monitoring settings or click Discard to clear the changes and go back to the previous settings.
Configuring OS10 administrator password
The OS10 admin user account is the default administrator account that is used to configure OS10.
To configure the OS10 administrator account password:
1. Click All Devices > I/O Modules > View Details > Settings > Management or Devices > I/O Modules > View Details >
Settings > Management.
The I/O Modules page is displayed.
2. Enter the Host Name and Root Password for the IOM.
NOTE: For OS10 versions 10.5.0.5 and earlier, the above procedure changed the password for the OS10 Linux admin
account. For OS10 versions later than 10.5.0.5, the above procedure changes the password for the OS10 admin user.
Configuring SNMP settings
To configure the SNMP settings:
1. Click All Devices > I/O Modules > View Details > Settings > Monitoring or Devices > I/O Modules > View Details >
Settings > Monitoring.
2. Select Enable SNMP to configure the SNMP version and community string.
Configuring advanced settings
To configure the advanced IOM settings:
1. Click All Devices > I/O Modules > View Details > Settings > Advanced or Devices > I/O Modules > View Details >
Settings > Advanced.
2. Select the options to replicate the chassis time and alert settings to the IOM.
Configuring ports
In SmartFabric mode, you can configure breakout and admin status, and MTU size for IOMs. You can configure port breakout
only for port groups.
In Full Switch Mode, the Port Information page is read-only. To make changes to switch interfaces, use the OS10 CLI and not
the GUI. Using the GUI can result in interface configuration issues.
NOTE: Ensure that the peer FC port has a fixed speed and matches the speed of the IOM FC port for the link to come up.
To configure breakout:
1. Click Devices > I/O Modules > View Details > Hardware > Port Information.
2. Select the port group and click Configure Breakout.
The Configure Breakout window is displayed.
3. Select the Breakout Type.
First apply "Hardware Default" and then select the required breakout.
NOTE: Breakouts can be configured only for Fabric Mode IOMs.
Configuring admin status
You can switch the admin status for all ports, which is enabled by default. For the MX9116n FSE port groups 1/1/15 and 1/1/16,
when you breakout the fiber channel ports, the admin status is disabled by default. Enable the status if required.
To switch the admin status:
Ethernet IO Modules
75